Home » General Health » How To Install Portable Hot Tub Electrical Wiring

Installing electrical to a new or used hot tub can be a daunting thought. Below are the major steps and lessons I learned when I recently installing new electrical wiring to my hot tub. You should also check with your local planning and zoning department to determine where you can find any local state or city code requirements. Many times the local jurisdictions will reference the NEC for hot tub electrical wiring, but it is good to check.

Create a scaled plan view drawing of the layout of your new electrical system. The layout should be to correct scale so you can use it to determine the linear feet of conduit, wire, and other materials you will need. You should also create any elevation drawings for conduit that goes up and down walls. This will help you when determining the number of fittings, elbows and conduit lengths needed.

If you do not have an unlimited Hot Tub Wiring Guys then you should research the cost to purchase all the materials prior to purchasing. You can research costs on line by going to the major box stores like Home Depot or Lowes, or you can make a trip to the store and determine how much each of the items will cost. After determining the cost of each item, multiply the cost of each item by the number of those items needed.

Once you have created your budget and assembled all the tools for your project it is time to go to the store and purchase your materials. I purchased my materials from Home Depot because it was close to my house, but you may have an electrical materials store close to your house. If you do have once close you should purchase your materials from there. Typically they will sell you materials for less cost than you would pay at a big box store.

They will also have a larger verity of electrical panels, breakers, and other materials. Remember than you can and should purchase more materials than what you think you will need. You can return any unused materials after your project is complete. This will save you time by not having to stop in the middle of your project to go to the store to purchase materials that you did not know you would need.

When you have routed all your conduit it is time to pull your electrical wire. If you followed some of the helpful hints provided at the bottom of this article then pulling your wire should not be too much of an effort. When it comes to installing the breaker in your main house panel, turn off your main house disconnect. This will remove power to all your breakers, thus allowing you to install the new breaker in the panel. Remember this will disable all the power to your house, so choose a time when no one is home or you don’t need power, preferably during the day so you don’t need your lights.

Published at: Recent Health Articleshttp://recenthealtharticles.org

Article Source

About

Leave a Reply

Your email address will not be published. Required fields are marked *